Creative DTT3500 Digital Guide de l'utilisateur télécharger pdf (Page 12)

12

Center Speaker Stand

Installation

Unlike the Desktop Stand (for

Satellites), the stands for the

Center Speaker are of the screw-in

type.

1. Align the Attachment Arm to

the Center Speaker (see

Diagram B).

2. Use the screw provided to

connect the Attachment Arm

to the Center Speaker.

Screw Mounting

Mounting the rear satellites on side

walls will give you superior surround

effects.

For a secure installation, mount the

rear satellites only on walls that are

structurally sound.

1. Place the following near you: rear

satellites, screws, plastic anchors

and rubber pads (supplied). You will

also need a drill and hammer.

2. Mark the wall where each rear

satellite screw will be. Position

the speakers behind you and

slightly above ear level.

3. Drill a hole about 2 cm (1 inch)

deep into each wall. Tap a plastic

anchor into the hole until it is

flush with the wall (see Diagram

C).

4. Screw a M5 x 25 mm screw into

each anchor, leaving about

0.5 cm (¼ inch) of the screw

protruding.

5. Apply four rubber pads on the

corners at the back of each rear

satellite. The rubber pads will

cushion the satellites from any

vibration and help keep them in

position.

6. Slip the keyhole of each rear

satellite onto a protruding screw

to complete the installation.

B

Attachment Arm

Mounting Speakers

C

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Commentaires sur ces manuels

Pas de commentaire