Creative DTT3500 Digital Guide de l'utilisateur télécharger pdf (Page 11)

11

Speaker Cable

Installation

Typically, the 3 meter (5 feet) Speaker

Cables will connect the front Satellites

and the Center Speaker to the Decoder

Amplifier and the 5 meter (9 feet)

Speaker Cables will connect the rear

Satellites to the Decoder Amplifier. A

panel of twelve self-adhesive labels is

provided to identify each Satellite and

Subwoofer and the opposite end of the

cable connected to a Satellite and

Subwoofer.

1. Identify a 3 meter Speaker Cable.

Most often, a Satellite will be used

with a Desktop Stand. In this case,

thread the bare cable end of a 3

meter Speaker Cable through the

hole in the Desktop Stand.

Connect this end to a Satellite (as

shown in

Diagram A

). Carefully

insert the Desktop Stand’s

attachment arm into the socket in

the back of the Satellite, taking up

any slack in the cable as required.

2. To use this Satellite in the front left

position, remove the backing from

the small, round “L” label and

apply it to the back of the Satellite

(see

Diagram A

).

3. Remove the backing from the

remaining, longer “L” label and

wrap it around the opposite end of

the Speaker Cable near the RCA

plug.

4. Place the Satellite in the front left

position.

5. Repeat this process using another

3 meter Speaker Cable for the

front right Satellite, using the “R”

labels.

6. Connect another 3 meter Speaker

Cable to the Center Speaker. Use

the “C” (center) labels. For details

on attaching Center Speaker

stands, see “Center Speaker Stand

Installation” on page 12.

7. Use the RS and LS labels (right

and left surround) and 5 meter

Speaker Cables for the rear

Satellites.

8. If you wish to use the Floor

Stands with the rear Satellites,

assemble the stand according to

the

Floor Stand Assembly

leaflet.

9. Use the last 3 meter Speaker

Cable and the “SUB” labels for

the Subwoofer.

Speaker Cable Usage

To connect the Speaker Cable to each

speaker, press one of the spring-

loaded tabs to expose the connection

hole.

Insert the bare end of the cable into

the exposed hole, then release the tab

to lock the cable in place. Connect

cables with red bands to red tab

connectors, and unmarked wires to

black tab connectors.

Notes:

Matching red cables to red

tabs and unmarked cables to black

tabs insures the speakers all play “in

phase”. “Out-of-phase” connections

will do no electrical harm, but the

overall sound quality will be greatly

reduced. You can substitute regular

18 gauge speaker cable to create

longer cables, if needed. The 5 meter

cables may also be used for the front

satellites if required.

Speaker

Cable and

Stand

Installation

A

Attachment

Socket

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Commentaires sur ces manuels

Pas de commentaire