Creative PC-CAM 350 Spécifications télécharger pdf (Page 15)

Installing PC-CAM 350 1-3

Buttons and

LCD on PC-

CAM 350

The following section explains the functions of the buttons and LCD on your PC-

CAM 350. Refer to Figure 1-1 and Figure 1-2 for the location of these buttons and

LCDs on your camera.

Buttons

The following buttons are found on your PC-CAM 350:

❑ Power button

To turn on your camera, press this button. You can only turn on your camera

when it is disconnected from the computer.

To turn off your camera, press and hold this button for two seconds.

Note: The camera will turn itself off if it is left idle for three minutes.

❑ Operation Mode button

This button will change the camera’s operation mode each time it is pressed.

There are six modes of operation: Single snapshot (normal resolution), Single

snapshot (high resolution), Single snapshot (low resolution), Self-timer single

snapshot (normal resolution), Self-timer single snapshot (high resolution),

Multiple snap shot and Video Recording. To erase all the data from your

camera, press this button together with the Snapshot button.

❑ Flash Mode button

This button will change the camera’s flash mode each time it is pressed. There

are two flash modes: Auto and Disabled. To delete the last file from the

camera, press the Flash Mode button and Snapshot button simultaneously.

❑ Snapshot button

This button is used for taking photos and videos. It is a two-stage button.

Pressing the button halfway (the first stage) will allow the camera to make the

necessary adjustments for flash and exposure. Pressing the button completely

(the second stage) allows the camera to take a picture or video.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 50 51

Pas de commentaire

Creative PC-CAM 350 Spécifications Page 15